the springs settled down a bit, i checked the heights this morning and its about 11.25 front 11.5 rear hub to fender (4.25 front, 4 rear at the pinch welds). took off the wheels to check and passenger rear perch was rubbing the axle so i cranked it up 1 turn. both front perches seem to be contacting the control arm on the outside edge. i'll likely raise it instead of lower it =( emilio suggested longer helper springs up front, but i measured it out and looks like i'll run in to the control arms more. i guess i'll just have to accept the fact that these just won't go as low as i want them to without making sacrifices that i dont want to make.
tried on Cuda's new rims, varrstoen 15x9 +15 with 195/50/15. the rims are beautiful and would fit great but definitely would want to be lower if i were to own these
also got my race seat back and reinstalled it, removed the cockpit brace, and Cuda cleaned my engine bay.
No comments:
Post a Comment